ESAB m3 G2 System Manual page 64

section 6
caution
cut angle
Negative Cut Angle
Top dimension is greater than the bottom.
• Misaligned torch
• Bent or warped material
• Worn or damaged consumables
• Standoff low (arc voltage)
• Cutting speed slow (machine travel rate)
Positive Cut Angle
Top dimension is less than the bottom dimension.
• Misaligned torch
• Bent or warped material
• Worn or damaged consumables
• High standoff High (arc voltage)
• Cutting speed fast
• Current high or low. (See Process Data for rec-
ommended current level for specific nozzles).
Before attempting anY corrections, check cutting variables with the
factory recommended settings/consumable part numbers listed in
process Data.
pt-36 plasma torch
Drop
Drop
64
Part
Part
Part
Part