SECTION 3
3.6 Torch Mounting
CAUTION
1.812 " (46mm)
Diameter Collar
Do Not Cover Vent Hole.
When mounting, do not to cover the small vent hole in
When mounting, do not to cover the small vent hole in
When mounting, do not to cover the small vent hole in
When mounting, do not to cover the small vent hole in
the side of the sleeve.
the side of the sleeve.
the side of the sleeve.
the side of the sleeve.
drain from inside the sleeve should a leak occur in a
drain from inside the sleeve should a leak occur in a
drain from inside the sleeve should a leak occur in a
drain from inside the sleeve should a leak occur in a
service line.
service line.
service line.
service line.
Torch Mounting Options.
Torch Mounting Options.
Torch Mounting Options.
Torch Mounting Options.
2.0 " (51mm)
Diameter Sleeve
•
•
Vent Hole
•
3-10
The torch is normally mounted by the 2.0 inch
diameter (51mm) sleeve. Do not cover vent hole.
For custom alternative mounting, the torch can be
mounted by the 1.812" (46 mm) dia collar shown.
This insulated collar and its shoulder are machined
relative to the nozzle retainer thread on the torch
body.
Use only specified mounting surfaces
INSTALLATION
This hole allows coolant to
This hole allows coolant to
This hole allows coolant to
This hole allows coolant to