Venting The Chamber Vacuum - Beckman Coulter Avanti J-HC Instructions For Use Manual

7
To vent the chamber vacuum, grasp the red rubber hose and pull it up until it comes off of the
pump fitting (see
a. Use a back-and-forth motion as you pull; this takes quite a bit of force.
The vacuum will be completely vented several seconds after the hose is detached.
NOTE
CAUTION
Do not twist the hose to the left (counterclockwise) as you pull the hose, or you
will unscrew the hose fitting.
Figure 3.3 Venting the Chamber Vacuum
A
2
C
PN J3HC-IM-5AD
Figure 3.3).
Several tubing lines are tied to the red hose. As you grasp the hose, place your hand over
these lines. Make sure that they stay connected as you pull.
Accessing the Rotor in Case of Power Failure
1
B
3
4
3
Troubleshooting
3-7