Hydroclean Function; Preparation Of The Amalgam Separator - KaVo Primus 1058 Life Care Instructions

2 Setup methods according to DIN EN ISO 17664 | 2.10 Preparation of the amalgam separator

2.9.2 HYDROclean function

The HYDROclean function is an automatic programme for hydro-mechanical cleaning
of the drainage and separation systems within and outside the treatment unit. The
cleaning process is carried out by the supply of fresh, clear water (limited rinsing). The
water is aspirated from the Aquamat through the filter housing to the separation sys‐
tem. The spittoon bowl rinsing is alternately turned on and off.
The HYDROclean function prevents the coagulation and adhesion of proteins inside
the drainage system and improves the transporting of fine particles.
Carrying out the HYDROclean function:
▪ After each treatment
Preparation
Requirement
Suction hoses remain hanging in the holder.
▶ Press the "HYDROclean" button.
ð
The HYDROclean function is in the preparatory stage.
Start the HYDROclean function
▶ Press the "HYDROclean" button.
ð
This starts-up the HYDROclean function.
The HYDROclean function is completed when the top LED goes dark.
The process can be discontinued at any time by pressing the "HYDROclean" button.

2.10 Preparation of the amalgam separator

The following systems can be used as options:
▪ "Dürr" Amalgam separator
▪ Preparation for external wet suction for connection to a central amalgam separator
▪ "Dürr" separation kit
31 / 40
Care instructions Primus 1058 Life