Visualization And Description Of Entries On The Plc - Automatic Systems PNG382 Field Manual

Follow the instructions below for each time-out (from %TM0 to %TM12) and monostable (%MN0 and
%MN1).
1. Press the %TM or %MN key followed by the corresponding number and ENTER.
2. Place the cursor on %TMx.P or %MNx.P with the vertical arrows.
3. Introduce the new value.
4. Press ENTER.
Example: %TM0 –Buzzer alarm duration
1. Press the %TM key followed by 0 and ENTER.
2. Place the cursor on %TM0.P with the vertical arrows.
3. Introduce the new value.
3. Press ENTER.

4.6. Visualization and description of entries on the PLC

FTX117 or
programme
reference
I3.0
I3.1
I3.2
I3.3
I3.4
I3.5
I3.6
I3.7
I3.8
I3.9
I3.10
I3.11
I3.12
I3.13
I3.14
I3.15
I3.16
I3.17
I3.18
I3.19
I3.20
I3.21
I3.22
I3.23
I3.24
I3.25
I3.26
I3.27
I3.28
I3.29
I3.30
I3.31
Note: In order to display the inputs from I16.0 to I16.15 thanks to the PLC LEDs, press the « DIAG » button
for less than one second until the digit 16 appears.
 Automatic Systems PNG38X-A3_1-04-gb-02.doc
PLC LED
0 Cell 1
1 Cell 2
2 Cell 3
3 Cell 4
4 Cell 5
5 Cell 6
6 Cell 7
7 Cell 8
8 Cell 9
9 Cell 10
10 Cell 11
11 Cell 12
12 Cell 13
13 Cell 14
14 Safety cell CS
15 VSC default
16.0 DIP – Key
16.1 DIP direction A – Input 1
16.2 DIP direction A – Input 2
16.3 DIP direction B – Input 1
16.4 DIP direction B – Input 2
16.5 DIP – Obstacle mode NO/NF
16.6 Door 1 opening limit switch
16.7 Door 1 closing limit switch
16.8 Door 2 opening limit switch
16.9 Door 2 closing limit switch
16.10 Card reader – Passage authorization – Direction A
16.11 Reader A – Badge denied
16.12 Evacuation
16.13 Card reader – Passage authorization– Direction B
16.14 Reader B – Badge denied
16.15 Safety extension
10/12/01
Attribution
p. 34/51