Technical Specifications; Performance Specifications; Power Requirements - Digi XBee-PRO S3 User Manual

Technical specifications

Performance specifications

This table describes the performance specifications for the devices.
Note Range figure estimates are based on free-air terrain with limited sources of interference. Actual
range will vary based on transmitting power, orientation of transmitter and receiver, height of
transmitting antenna, height of receiving antenna, weather conditions, interference sources in the
area, and terrain between receiver and transmitter, including indoor and outdoor structures such as
walls, trees, buildings, hills, and mountains.
Specification
Ideal RF line-of-sight
range
Transmit power output
RF data rate (high)
RF data rate (low)
Serial UART interface
Serial interface data
rate (software
selectable)
Receiver sensitivity
(typical)

Power requirements

The following table describes the power requirements for the XBee-PRO 900HP RF Module.
Specification
Supply voltage
Transmit current
Idle/receive current
Sleep current
1 Supply voltages of less than 3.0 V may reduce performance. Output power and receiver sensitivity may
degrade.
XBee®-PRO 900HP/XSC RF Modules
Value
10 kb/s: up to 9 miles (15.5 km)
200 kb/s: up to 4 miles (6.5 km)
(with 2.1 dB dipole antennas)
24 dBm (250 mW) (software selectable)
200 kb/s
10 kb/s
Complementary metal–oxide–semiconductor (CMOS) Serial universal
asynchronous receiver/transmitter (UART), baud rate stability of <1%
9600-230400 baud
-101 dBm, high data rate
-110 dBm, low data rate
Value
1
2.1 to 3.6 VDC
PL = 4: 215 mA typical, (290 mA max)
PL = 3: 160 mA typical
PL = 2: 120 mA typical
PL = 1: 95 mA typical
PL = 0: 60 mA typical
29 mA typical at 3.3 V (35 mA max)
2.5 µA (typical)
Performance specifications
16