Table of Contents
Advertisement
High-Level Diagnostic Tools, Processes and References
If a Problem is Found
If a problem is found, do the following checks:
1. Verify that all relevant hardware is turned on.
2. Verify that the M9302A paths are correctly set from the SFP and that the signal generator is set to the proper
power/frequency and that all cables are properly connected. All SMA connectors are torqued to 8 Lb-In (0.904
Nm).
3. Check that the Status LED is green.
4. Verify that the ACCESS LED flashes each time the module is written to.
5. See
Performance Verification Tests
tory-set specifications.
If you need to swap a defective module with a core replacement module from Agilent, see
ment
(page 32).
20
(page 21) to verify the module is performing according to published, fac-
Agilent M9302A PXI Local Oscillator Service Guide
Module Core Replace-
Advertisement
Table of Contents
