Pb Lead-Acid Battery Program - HITEC X4 AC Pro Instruction Manual

Pb (Lead Acid) Battery Program
This program is only suitable for charging Pb (lead-acid) batteries with nominal
voltages of 2 to 20V. A Pb (lead-acid) battery is significantly different from NiCD/
NiMH batteries. Pb batteries can only deliver current lower in comparison
to their capacity. The same restriction applies to the charging process.
Consequently, the optimum charge current can only be 1/10 of the capacity.
A Pb battery cannot be used for fast charging. Please follow the instructions
provided by the battery manufacturer.
The X4 AC Pro offers the following Pb charge modes: Charge and Discharge.
Pb Charge Mode:
BEFORE YOU BEGIN CHARGING/DISCHARGING YOUR BATTERY, MAKE
SURE YOU HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND
SAFETY INFORMATION CONTAINED ON PAGES 3 ~ 7.
Warning
Pb CHARGE
2.0A
Pb HARGE
c
2.0A
be set to 1/10 of capacity. For example if you are charging a 7Ah battery the charge
rate should be set to 0.7A. Follow the instructions provided with your battery when
setting the amp rate.
Pb CHARGE
2.0A
Press and hold the START/ENTER button and charging will begin.
Pb 1.3A 5.90V
CHG 005:33 00581
charging current, battery voltage, charging time and charged capacity.
When charging is complete, the screen will read "FINISHED" and the charger will emit
a chiming sound.
28
After selecting the correct battery type, use the INC or
6.0V(3P)
DEC buttons to change it to the "CHARGE" mode.
Press the START/ENTER button and the amp rate value
will begin flashing. Use the INC or DEC buttons to adjust
6.0V(3P)
the value to the desired charge rate. The amp rate should
Press the START/ENTER button again and the voltage
rate value will begin flashing. Use the INC or DEC
6.0V(3P)
buttons to set the voltage and number of cells.
Once charging has commenced, the charger will display
66
the following real-time information: battery type,