Lithium Battery Program [Lip0/Lihv/Life/Lilon] - HITEC X4 AC Pro Instruction Manual

Lithium Battery Program
This program is only suitable for charging/discharging Lithium chemistry
batteries (LiPo, LiHV, LiIon and LiFe). The X4 AC Pro offers the following lithium
charge modes: Charge, Balance Charge, Fast Charge, Storage and Discharge.
The example shown here if for charging a LiPo battery in Balance Mode.
Whenever a parameter value in the program needs to be adjusted, highlight
the value by pressing the START/Enter button to make it blink; to change the
value press the DEC or INC buttons. The new value will be stored by re-press-
ing the START/Enter button. If there is another parameter to be adjusted as
part of a range on the same screen, it will start blinking after the first param-
eter value has been confirmed.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SAFETY
INFORMATION CONTAINED ON PAGES 3-7.
Warning
Lithium Battery (LiPo, LiHV, LiFe, LiIon) Charge Modes
The following steps will guide you through setting up a Lithium Chemistry Bat-
tery in a Charge Mode. These instructions apply to Charge, Balance Charge, Stor-
age Charge and Fast Charge. For the purpose of this example we will use balance
charge as it is the safest way to charge Lithium Batteries.
BATT/PROGRAM
LiPo BATT
BEFORE SELECTING A CHARGE MODE, IT IS CRITICAL THAT YOU SELECT
THE CORRECT TYPE OF LITHIUM BATTERY TO BE CHARGED. FAILURE TO DO
SO CAN RESULT IN DAMAGE TO THE BATTERY AND POSSIBLE EXPLOSION.
Warning
LiPo BALANCE
2.0A
18
BATT/PROGRAM Select
Press INC and DEC to cycle through all battery types
and press START/ENTER to select the appropriate
battery types to be charged.
Mode Select
11.1V (3S) Press INC and DEC to scroll through all available
modes. If you want to balance charge your battery,
select BALANCE mode. Press the START/ENTER button
to confirm the mode of your choice.