HITEC X4 AC Pro Instruction Manual page 19

Lithium Battery Program (continued)
LiPo BALANCE
2.0A 11.1V (3S)
SETTING A CHARGE CURRENT THAT IS TOO HIGH CAN HAVE DAN-
GEROUS RESULTS. NEVER EXCEED THE BATTERY MANUFACTUR-
ERS RECOMMENDED CHARGE RATE
Warning
LiPo BALANCE
2.0A 11.1V (3S)
Now that you have set all the parameters for your battery you are ready to exe-
cute the operation. Now would be a good time to check to make sure the charge
settings are correct and within the battery manufacturers recommendations.
DURING CHARGING/DISCHARGING, THE BATTERY SHOULD BE PLACED
INSIDE A FIRE PROOF/RETARDANT BAG AND ON A FIRE PROOF SUR-
Caution
FACE, AWAY FROM OTHER COMBUSTIBLE OBJECTS.
BATTERY CHECK
WAIT.....................
R:3SER S:3SER
CANCEL (STOP)
R:3SER S:3SER
CONFIRM (ENTER)
Charge Status Monitor
Use the INC. and DEC. buttons to scroll through the various information dis-
played during the process.
LP3s 3.2A 11.87V
BAL 010:01 00609
Charge Current
Press INC and DEC to adjust the charge current. Press
the START/ENTER button to confirm the setting of
your choice. Adjustment range is 0.1 ~ 10.0 Amps.
Battery Cells
Press INC and DEC to scroll through the battery cells
supported by the charger. Press START/ENTER to select
the appropriate cells for your battery.
Program Start
Press and hold the START/ENTER button until you
see "BATTERY CHECK... " followed by the confirmation
screen. This screen displays the number of cells
you set up as "R" and the number of cells detected by
the processor as "S". If both numbers are identical, you
may press the START button once to confirm and
begin charging. If these numbers do not match, press
the STOP button to return to the previous screen and
carefully check the number of cells before proceeding.
This screen shows the type of battery, number of cells,
66
charge/discharge current, total voltage of the pack,
type of process, elapsed time and number of mAh fed
into the battery.
19