HITEC X4 AC Pro Instruction Manual page 16

Battery Type
LiPo
Lilon
LiFe
LiHV
NiMH
NiCd
Pb
(Lead Acid)
16
Process Description
The charge mode is for charging LiPo/LiFe/LiIon/
CHARGE
LiHV batteries in normal mode.
This mode is for discharging
DISCHARGE
LiPo/LiFe/LiIon/LiHV batteries.
This program is for charging or discharging a
STORAGE lithium battery which will not be used again for
an extended period of time.
A fast charge will result in a smaller than usual
FAST CHG charging capacity but will reduce the total
charge time.
This mode is for balancing the voltage of Lithium
BAL CHARGE
battery cells while charging.
The charger will charge NiMH and NiCd batteries
CHARGE
using the charge current set by the user.
In this program, the charger detects the condi-
tion of the connected battery and automatically
charges the battery.
AUTO CHG
Note: You should set the upper limit of the charge
current to avoid damage by excessive charging current.
The X4 AC Pro may not be able to detect the charge
capacity of low resistance batteries.
DISCHARGE
This mode is for discharging a NiMH/NiCd battery
In re-peak charge mode, the charger can peak
charge the battery once, twice, or three times
in a row automatically. This is good for
RE-PEAK
confirming the battery is fully charged and for
checking how well the battery receives
fast charges.
Automatically charges/discharges the battery up
CYCLE
to 5 times. This process can enhance the perfor-
mance of NiMH/NiCd batteries.
CHARGE
This mode is for charging a Pb battery.
DISCHARGE
This mode is for discharging a Pb battery.