HITEC X4 AC Pro Instruction Manual page 24

NiMH / NiCd Battery Program (cont.)
BATTERY CHECK
............................
NiMH 1.3A 6.00V
CHG 009:11 00411
Once the battery is fully charged, the screen will read "END: FINISHED" and the
charger will emit a chiming sound. You can press the ■ button at any time during the
charging process to stop charging.
NiMH / NiCd Auto Charge Mode
In this mode, the charger automatically detects the connected NiMH or NiCd
battery and determines the proper full charge and cutoff thresholds. Setting the
upper charge current limit for safe levels based on your battery specifications
will ensure safe charging of your specific battery. If you are unsure of the
maximum allowable charge rates, set the charger to a maximum of 1C (battery
mAh/1000, i.e., 2500mAh = 2.5A).
NiMH Auto CHARGE
CURRENT
NIMH CHARGE
CURRENT
Program Start
Press and hold the START START/ENTER button until you see "BATTERY
CHECK..." the battery should then begin charging.
Once the battery is fully charged, the screen will read "END: FINISHED" and the
charger will emit a chiming sound. You can press the ■ button at any time during the
charging process to stop charging.
24
Program Start
Press and hold the START START/ENTER button until
you see "BATTERY CHECK..." the battery should then
begin charging.
Once charging has started the screen will display the
66
battery type, charge rate, total pack voltage, elapsed
time, and total current fed in mAh.
After selecting the correct battery type use the INC
and DEC to scroll to Auto CHARGE Mode. Press the
2.0A
START/ENTER button to confirm.
Setting the Charge Current
2.0A Press INC and DEC to increase or decrease the charge
current. Press the START/ENTER button to confirm the
setting. The rate can be adjusted from 0.1 ~ 10A.