HITEC X4 AC Pro Instruction Manual page 20

Lithium Battery Program (continued)
3.81 3.82
0.00 0.00
Fuel = 66%
Cell = 3.98V
Program Stop
During the charging process, press STOP button to stop the process.
[ END: FINISH
12.60V 02001mAh
TIME: 00:32:15
12.60V 02001mAh
NOTE: The battery charge indicator displays
during discharging.
Lithium Battery (LiPo, LiHV, LiFe, LiIon) Discharge Mode
The following steps will guide you through setting up a Lithium Chemistry Bat-
tery Discharge Mode.
DISCHARGING LITHIUM CHEMISTRY BATTERIES CAN CAUSE PERMANENT
DAMAGE TO THE BATTERY AND IT IS NOT RECOMMENDED FOR
ANYTHING OTHER THAN THE DISPOSAL OF THE BATTERY. IF YOU CHOOSE
TO DISCHARGE YOUR LITHIUM BATTERIES, MAKE SURE TO PAY CLOSE
ATTENTION TO THE MINIMUM VOLTAGE SETTING. IF YOU WANT TO STORE
Warning
YOUR BATTERY FOR A LONG PERIOD OF TIME YOU SHOULD UTILIZE THE
STORAGE MODE CHARGE PROGRAM AS THIS IS THE SAFEST METHOD OF
STORING YOUR LITHIUM CHEMISTRY BATTERIES.
LiPo DISCHARGE
2.0A
LiPo DISCHARGE
2.0A
20
3.81
This screen shows the voltage of each individual cell
66
0.00
when a balancing cable is connected.
Charged capacity percentage and average cell voltage
66
of the pack.
Program Complete
]
When the charging process is finished, an audible
100
sound will be heard and the charger will indicate
END: FINSHED. The charger displays the total pack
100
voltage, total mAh fed into the battery and the
elapsed time of the process.
BATT/PROGRAM Select
11.1V (3S)
Press INC and DEC to cycle through all battery types
and press START/ENTER to select the appropriate
battery types to be charged.
Discharge Current
Press INC and DEC to adjust the discharge current.
11.1V (3S)
Press the START/ENTER button to confirm the setting
of your choice. Adjustment range is 0.1 ~ 2.0 Amps.
Green
during charging and
Red