Getting Started - HITEC X4 AC Pro Instruction Manual

Getting Started

Initial Setup of the Charger
After connecting the battery, you are now ready to set up the charger to
charge your specific type of battery. When the charger is first powered
on, it will start at Channel A. The default mode of the charger is for a
regular charge mode of a 2 Cell (7.4V) 2000 mAh Lithium Polymer battery.
If this is not the battery you plan on working with, then you will need to
make changes to the operation programming based on the following
instruction.
BEFORE SELECTING AN OPERATION, IT IS CRITICAL THAT YOU
KNOW THE TYPE OF BATTERY YOU ARE WORKING WITH AND WHAT
THE MANUFACTURER RECOMMENDATIONS ARE FOR CHARGING OR
DISCHARGING. FAILURE TO FOLLOW THE MANUFACTURERS REC-
Warning
OMMENDATIONS CAN RESULT IN DAMAGE TO THE BATTERY AND
POSSIBLE EXPLOSION.
Input Buttons
Channel Select
Button
Batt. Type/Stop Button
Stop the progress of
the current action
or cycle back to the
previous step/screen.
Available Operations
Depending on the battery type, different operations will be available. The
chart on the following page shows which operations are available for the
different types of batteries the X4 AC Pro is capable of working with.
DEC. Button
Scroll through available menus
or decrease parameter values.
Start/Enter Button
Start the progress of the
current action or cycle into
the next step/screen
INC. Button
Scroll through available menus
or increase parameter values.
15