HITEC X4 AC Pro Instruction Manual page 31

Item
Rest Time
CHG>DCHG 10min
NiMH Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
Key Beep ON
Buzzer ON
DC Input Low
Cut-Off 11.0V
BAL. Connection
ON
AC Max Power Set
100W
Load Factory Set
Enter
Version
HW 1:01 SW1:00
Selection
Rest time allows the battery to cool
1 - 60
down between charging/discharg-
Minutes
ing cycles
This setting is for NiMH/NiCd
batteries only. When the charger
Default: 4mV/Cell detects that the delta peak value
you set has been reached, the
3 ~ 15mV/Cell
charger will indicate the battery is
fully charged.
Key Beep sounds every time you
press a button. Buzzer beep or
ON / OFF melody sounds at various instanc-
es during operation to alert you to
certain process events.
This setting controls the DC input
voltage. If the voltage drops below
10.0 ~ 11.0V the value you set the charging
operation will be terminated to
protect the charger.
The default setting for charg-
ing Lithium batteries is to use a
balance adaptor to connect the
ON / OFF battery and charger in Charge, Fast
Charge, Balance Charge and Stor-
age modes. This function could be
disabled here.
See Page 12 for a complete expla-
O - 100 nation of the Power Distribution
Function
Press ENTER to load the factory
default settings
Indicates the hardware and firm-
ware versions
Description
31