HITEC X4 AC Pro Instruction Manual page 33

Memory Preset - Data Save/Load
DSCH CURRENT
1.0A
DSCH VOLTAGE
3.0V/CELL
TVC YOUR RISK
4.20V
CHANGING THE TERMINAL VOLTAGE IS ONLY INTENDED FOR EXPERT
USERS, ANY CHANGES TO DEFAULT SETTINGS ARE COMPLETELY
AT YOUR OWN RISK. DO NOT EXCEED BATTERY MANUFACTURERS
Warning
RECOMMENDATIONS
TRICKLE
OFF
PEAK DELAY
5 Min
SAVE PROGRAM
ENTER
[ BATT MEMORY 1 ]
LiPo 7.4 (2S)
[ BATT MEMORY 1 ]
C:4.0A D:1.0
Recall Memory:
BATT/PROGRAM
BATT MEMORY
[ BATT MEMORY 1 ]
LiPo 7.4 (2S)
LiPo BALANCE
2.5A 7.4V(2S)
Discharge Current: Enter the desired discharge
current.
Per Cell Discharge Voltage: Enter the desired end
per cell voltage.
Terminal Voltage (Lithium Batteries): Sets the
upper per cell charge voltage:
Trickle (NiMH/NiCd): OFF or 50 ~ 300mAh Sets the
desired trickle charge voltage once the battery has
reached full charge.
Peak Delay (NiMH/NiCd): OFF or 1 ~ 5 minutes.
Sets the time between re-peak cycles
Save Program: Press the ENTER/START button
to save the program. SAVE..... will appear
momentarily while the program is written to the
memory.
Once saved the screen indicate the memory
number, battery type, cell count, charge current
and discharge current.
From the BATT/PROGRAM menu use the INC or DEC
buttons to scroll to the BATT MEMORY program and
press ENTER/START button to enter the battery
memory program . Scroll to the memory number
you wish to use then press and hold the ENTER/
START button for 3 seconds to begin the selected
process.
33