HITEC X4 AC Pro Instruction Manual page 26

NiMH / NiCd Battery Program (cont.)
IN RE-PEAK MODE, THE X4 AC PRO USES THE CHARGE AMPERAGE
AND VOLTAGE SETTINGS ENTERED IN CHARGE MODE (SEE PAGE 20.
Note
NiMH
NiMH
Program Start
Press and hold the START START/ENTER button until you see "BATTERY
CHECK..." the battery should then begin Re-Peak charging.
NiMH 1.3A 5.90V
RPC 005:33 00581
Once the Re-Peak process has completed, the screen will read "END: RE-PEAK"
and the charger will emit a chiming sound. The X4 AC Pro will display the
charge/discharge capacity for each cycle. Using the + and - buttons, you can
scroll through this data for each cycle.
NiCD/NiMH Cycle Mode
The X4 AC Pro makes cycling of NiCD/NiMH batteries easy. The process of
discharging and recharging (cycling) can be achieved automatically with one
simple step and will improve the performance of NiCD/NiMH batteries. We
strongly recommend cycling any battery that has been discharged and stored
for a period of time. This will increase battery life and improve performance.
FOR CYCLING, THE X4 AC PRO USES THE CHARGE/DISCHARGE AMPERAGE
AND VOLTAGE SETTINGS ENTERED IN THE CHARGE AND DISCHARGE
MODES (SEE PAGES 20 ~ 22).
Note
NiMH CYCLE
CHG>DCHG
26
After selecting the correct battery type, use the INC or
RE-PEAK
1
DEC buttons to select the "RE-PEAK" mode. Press the
START/ENTER button to confirm.
The number of Re-Peak cycles will begin flashing use
RE-PEAK
1 the INC or DEC buttons to select the number of Re-
peak cycles you want to perform up to 3 total cycles.
Once Re-Peak process has begun, the charger will
66
display the following real-time information: battery
type, charging current, battery voltage, elapsed time
and charged capacity.
After selecting the correct battery type use the INC
1
and DEC to scroll to CYCLE Mode. Press the START/
ENTER button to confirm.