3-2-11 Monitoring The Run Status Of Function Blocks; Wireless Debugging (Lcb01/03/05 Ver. 3.0 Or Later) - Omron SYSMAC CS Series Operation Manual

Description of Operation
Note

3-2-11 Monitoring the Run Status of Function Blocks

When monitoring the
run status common to
all function blocks
Check method
1. RUN LED on front panel of Loop Control-
ler
2. Monitor the run status (Execute - Run -
Monitor run status) on CX-Process Tool
3. ITEM015 of System Common block
ITEM016 of System Common block
ITEM017 of System Common block
When monitoring the
run status of
individual function
blocks
Method
1. Monitor the run status (Monitor run status
- Start) on CX-Process Tool
2. ITEM000 of each function block

3-2-12 Wireless Debugging (LCB01/03/05 Ver. 3.0 or Later)

Calibration Mode
Function Blocks and ITEMs
Function block and Block Model
2-position ON/OFF (Block Model
001)
3-position ON/OFF (Block Model
002)
Basic PID (Block Model 011)
Advanced PID (Block Model 012)
Blended PID (Block Model 013)
Batch Flowrate Capture (Block
Model 014)
Indication and Setting (Block
Model 031)
120
When STOP is switched to RUN, bumpless processing of the MV output value
does not function (as a result, the startup time required for high-speed tem-
perature-rise control can be shortened).
When the calculations are stopped for each function block, alarm processing
and PV input processing also stop. When the RUN/STOP switch is used for
starting and stopping, PID calculations only can be stopped (specified MV is
output) or started.
The run status of function blocks can be monitored as follows:
The run status common to all function blocks on the Loop Controller can be
monitored by one of the following methods.
Lit
1 (ON): Hot start in progress or
cold start in progress
0 (OFF)
Hot start: 1 (ON)
Cold start: 1 (ON)
The run status of individual function blocks can be monitored by either of the
following methods when the run status common to all function blocks on the
Loop Controller is "running."
No indication
0 (OFF)
Wireless debugging refers to the function that performs online debugging of
created function blocks. Wireless debugging uses the following mode.
This mode enables pseudo-inputs (fixed values) to be forcibly set in the PV
(process value) for the following function blocks.
ITEM number Settable ITEM
007 PV [PV input value]
007 PV [PV input value]
007 PV [PV input value]
007 PV [PV input value]
007 P1 [P1 input value]
007 P1 [P1 input value]
007 PV [PV input value]
Running
Out
1 (ON): Stopped
1 (ON)
0 (OFF)
0 (OFF)
Running
"Stopped" indicated
1 (ON)
Maximum setting Minimum setting
115.00 (%)
115.00 (%)
115.00 (%)
115.00 (%)
9,999
9,999
115.00 (%)
Section 3-2
Stopped
Stopped
−15.00 (%)
−15.00 (%)
−15.00 (%)
−15.00 (%)
0
0
−15.00 (%)