Unipulse F600AT Operation Manual page 42

■ Graphic mode
Select the method of drawing.
Alternatives:
［CONTINUITY］ ［SINGLE］ ［LEVEL］
□ Explanation of each alternative
［CONTINUITY］ Drawing is started by the
key is input.
Drawing is started by the
［SINGLE］
Drawing is started when the drawing weight exceeds the trigger level, or the
［LEVEL］
START
In drawing in the discharge mode, an "×" mark is drawn when the net weight
exceeds the following:
［Final weight – SP1］ ［Final weight – SP2］ ［Final weight - CPS］
■ Trigger level
Set the graph drawing start level (trigger level) if [LEVEL] has been selected by graphic mode
selection.
Setting range: 00000 to 99999
■ X-axis (time) end point
Set the time to display one screen.The setting range is from 2 sec. to 98 sec. (at intervals of 2 sec.)
The X-axis (time) end point can also be set from the graph screen.
Setting range: 2 to 98 (sec.)
■ Y-axis (load) start point
Set the graph drawing start point. (±00000 to ±99999)
Setting range: ±00000 to ±99999
■ Y-axis (load) end point
Set the graph drawing end point.The Y-axis (load) end point can also be set from the graph screen.
Note) The start point should be smaller than the end point.
Setting range: ±00000 to ±99999
■ Drawing weight selection
Select the weight for drawing.
Alternatives:
［GROSS］ ［NET］
START
START
key, and only one screen is drawn.
key, and drawing is repeated until the
key, and only one screen is drawn.
8.GRAPH SETTING
STOP
33