6． How To Set The Functions; For Hi/Lo Limit Comparison; (When "Hi-Lo Comp" Is Selected By Comp Mode Sel.) - Unipulse F600AT Operation Manual

6.HOW TO SET THE FUNCTIONS
6. HOW TO SET THE FUNCTIONS
□
Code No. selection
Press the /
Setting range:
When each item is set with the code No. specified as "ALL," the same set value enters into all of code
0 to 7 on the set item. This function is convenient when there is any item you want to set all code in
common.
□ Code copy
Code can be copied. Press the
screen. Set source and copy.
Setting range:

■ For HI/LO limit comparison

(when "HI-LO comp" is selected by comp mode sel.)

Setting item
[HH]
[HI]
[LO]
[LL]
When the weight value ＞ HI-HI limit, the status display "HH" lights, and the signal output "HH/SP1"
turns ON.
When the weight value ＞ HI limit, the status display "HI" lights, and the signal output "HI/OVER"
*1
turns ON.
When the LO limit ＜ weight value ＜ HI limit, the status display "GO" lights, and the signal output
"GO/SP2" turns ON.
When the weight value ＜ LO limit, the status display "LO" lights, and the signal output "LO/
UNDER" turns ON.
When the weight value ＜ LO-LO limit, the status display "LL" lights, and the signal output "LL/SP3"
turns ON.
Select the weight value from net or gross.
*1: Output when the HI/LO limit comparison output is in the "NORMAL" mode.
For the "COMPARATOR" mode, refer to page 31.
26
key on the each code setting screen, and specify the code No. you want to set.
［0 to 7］ ［ALL］
key on the each code setting
COPY
Source: (0 to 7)
Copy: (0 to 7)
Input range
±00000 to ±99999
±00000 to ±99999
±00000 to ±99999
±00000 to ±99999
*1
*1