Installation Of The Dynamic Scale (Optional) - Neopost IJ70 Manual

- Align the dynamic scale with the franking machine;
- Push the dynamic scale towards the machine, taking care to
- Thread the dynamic scale screw into the franking machine.
tightening knob
- Align the feeder with the dynamic scale;
- Push the feeder towards the dynamic scale, taking care to keep
- Thread the feeder screw into the dynamic scale. Then, using the
4149884V/A
15/10/2010

1.2.4 Installation of the dynamic scale (optional)

The equipment including a dynamic scale (the whole
system representing approximately 55 kg) requires the
use of a steady and rigid table, in order to prevent any
weighing problem.Be sure not to install the machine in an
area exposed to the sunlight or to draughts
keep the centering pin aligned as indicated;
Then, using the tightening knob, push and screw to lock (if the
two devices are not closing properly, slightly rotate the gear
protruding from the dynamic scale and repeat the operation).
(on the side)
the centering pin aligned as indicated;
tightening knob, push and screw to lock (if the two devices are
not closing properly, slightly rotate the gear protruding from the
feeder and repeat the operation).
centering pin
(gear)
Overall presentation
ORIG0473-19
19