7-Segment Led - Mitsubishi Electric Melservo MR-J5-G Series User Manual

Test operation select switch (SW3-1)
To use the test operation mode, turn "ON (up)" the switch. Turning "ON (up)" the test operation select switch enables the test
operation mode. In the test operation mode, the functions such as JOG operation, positioning operation, and machine
analyzer are available with MR Configurator2.
Page 43 Test operation
Disabling control axis switches (SW3-2, SW3-3, and SW3-4)
Turning "ON (up)" the disabling control axis switch disables the corresponding servo motor. The servo motor will become in
the disabled-axis state and will not be recognized by the controller.
Rotary switches (SW1/SW2)
The IP address of the servo amplifier can be set with the rotary switches (SW1/SW2). SW1 indicates an upper digit and SW2
indicates a lower digit of a hexadecimal. The initial setting is 01h.
To apply the settings of the rotary switches, set "0" (The rotary switch is used.) in [Pr. NPA01 IP address setting]. To set the
address without using the rotary switches, turn them to 0 and use an engineering tool.
For how to set IP addresses, refer to IP address setting function" in the following manual.
MR-J5 User's Manual (Communication Function)

7-segment LED

The network connection status, servo status, and alarm/warning occurrence statuses can be checked on 7 segment LED
display.
Display sequence
The following shows the display sequence of the 7-segment LED display from the power-on. After the completion of system
check and start of servo amplifier, the network connection status will be displayed.
Servo amplifier power on
Controller power on
(Network communication start)
*1
Controller power off
*1 The segment of the last 2 digits shows the network address.
Page 30 When the network is connected
Controller not connected
Controller not connected
(Initialization communication in progress)
Controller is connected
3.2 Switch setting and display of the servo amplifier
3
3 STRUCTURE
29