Mitsubishi Electric Melservo MR-J5-G Series User Manual page 32

Alarm display
When an alarm/warning occurs, alarm status is displayed following the network connection status. For example, the following
shows when [AL. 032.2 Overcurrent] is occurring.
■1-axis servo amplifier
Network status
After 1.6 s
■2-axis servo amplifier
Network status
After 1.6 s
When the network is connected
The following shows the network connection status. The servo status is displayed with the decimal points.
1-axis servo amplifier
Servo status
Off: Indicates ready-off and servo-off status.
Blinking: Indicates ready-on and servo-off status.
On: Indicates ready-on and servo-on status.
The last 2 digits shows the address for network.
Network
CC-Link IE TSN
3 STRUCTURE
30
3.2 Switch setting and display of the servo amplifier
Blank Status display
After 0.2 s
Status display
(1 digit)
: Indicates that an alarm is occurring.
Blank Status display
After 0.2 s
A-axis status
(1 digit)
: Indicates that an alarm is occurring.
Status display
B-axis status
(1 digit)
2-axis servo amplifier
B-axis servo status
A-axis servo status
Off: Indicates ready-off and servo-off status.
Blinking: Indicates ready-on and servo-off status.
On: Indicates ready-on and servo-on status.
Alarm No.
After 0.8 s After 0.8 s
Alarm No. (3 digits)
Alarm No.
After 0.8 s After 0.8 s
Alarm No. (3 digits)
Alarm No.
After 0.8 s After 0.8 s
Alarm No. (3 digits)
Address
The network address is displayed in hexadecimal.
Alarm detail Blank
After 0.8 s
Alarm detail
(1 digit)
After 0.2 s
Alarm detail Blank
After 0.8 s
Alarm detail
(1 digit)
After 0.2 s
Alarm detail Blank
After 0.8 s
Alarm detail After 0.2 s
(1 digit)
3-axis servo amplifier
C-axis servo status
B-axis servo status
A-axis servo status
Off: Indicates ready-off and servo-off status.
Blinking: Indicates ready-on and servo-off status.
On: Indicates ready-on and servo-on status.