Chapter 3 Structure; Parts Identification - Mitsubishi Electric Melservo MR-J5-G Series User Manual

3
STRUCTURE
3.1

Parts identification

MR-J5-350G or less
The following figure is the MR-J5-10G-RJ.
Inside of the display cover
(1)
(3)
No. Name
(1) Display section
(2) Network status display LED
(3) Rotary switches (SW1/SW2)
(4) DIP switch (SW3)
(5) Ethernet cable connector (CN1A)
(6) Ethernet cable connector (CN1B)
(7) USB communication connector (CN5)
(8) Analog monitor connector (CN6)
(9) STO input signal connector (CN8)
3 STRUCTURE
24
3.1 Parts identification
RUN
MS (2)
ERR
NS
SFTY
(14)
(4)
(20)
Side
(15)
(16)
(17)
Application
The 3-digit, 7-segment LED display shows the servo status and
alarm number.
Displays each network status.
Set the address of the servo amplifier.
To change the mode to the test operation mode, set the switch.
(SW3-1)
Connect the controller, servo amplifier or each network connected
device.
Connect the servo amplifier or each network connected device.
Connect with a personal computer.
Outputs the analog monitor.
Connect an external safety relay to use the STO function.
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(18) (19)
Bottom
Detailed explanation
Page 28 Switch setting and
display of the servo amplifier
Page 32 CN1A/CN1B
connector LED

Refer to "Connectors and pin
assignment" in the following
manual.
MR-J5 User's Manual
(Hardware)
Refer to "When using STO
function" in the following manual.
MR-J5 User's Manual
(Hardware)