Mitsubishi Electric Melservo MR-J5-G Series User Manual page 28

MR-J5W_-_G
Inside of the display cover
(1)
(2)
No. Name
(1) Display section
(2) Rotary switches (SW1/SW2)
(3) DIP switch (SW3)
(4) Network status display LED
(5) Main circuit power connector (CNP1)
(6) Control circuit power connector (CNP2)
(7) A-axis servo motor power connector
(CNP3A)
(8) B-axis servo motor power connector
(CNP3B)
*1
(9) C-axis servo motor power connector
(CNP3C)
(10) Charge light
(11) Protective earth (PE) terminal
(12) Ethernet cable connector (CN1A)
(13) Ethernet cable connector (CN1B)
(14) USB communication connector (CN5)
(15) STO input signal connector (CN8)
3 STRUCTURE
26
3.1 Parts identification
RUN
(10)
(4)
MS
ERR
NS
SFTY
(5)
(3)
(22)
Side
(6)
(7)
(8)
(9)
(11)
Application
The 3-digit, 7-segment LED display shows the servo status and
alarm number.
Set the address of the servo amplifier.
Consists of the test operation switch and control axis deactivation
switch.
Displays each network status.
Connect the input power supply.
Connect the control circuit power supply and regenerative option.
Connect the A-axis servo motor.
Connect the B-axis servo motor.
Connect the C-axis servo motor.
When the main circuit is charged, this light is up. While the light is
up, do not change the wire connection and the like.
Protective earth terminal
Connect the controller, servo amplifier or each network connected
device.
Connect the servo amplifier or each network connected device.
Connect with a personal computer.
The connector is not available for the STO function. Do not
remove the short-circuit connector.
(21)
Top
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
Detailed explanation
Page 28 Switch setting and
display of the servo amplifier
Refer to "Explanation of power
supply system" in the following
manual.
MR-J5 User's Manual
(Hardware)

Refer to "Explanation of power
supply system" in the following
manual.
MR-J5 User's Manual
(Hardware)
Page 32 CN1A/CN1B
connector LED

