Table of Contents
Advertisement
6.12.2. Initial setup
Enabling the Application Launcher
Settings for the Application Launcher
Tap the Settings button to set up the Application Launcher.
The values set in the Settings menu are saved in the ¥Flash¥system¥CeAdmin.ini (the file is not a registry
A
setup file created in the host computer or the other BHT can be copied to the CeAdmin.ini file instead of u
th
e Settings menu.
Reset or full reset is required after the initial setup.
The Application Launche
To enable the Application Launcher
Enabling takes effect at r
Step 1
Open the System Properties by tapping 3:System Properties
in the System Menu.
Step 2 Tap the
Startup Config icon in the System Properties.
Step 3
Tap the Password tab to display the screen shown on the left.
S
tep 4 Check the "
Enable Application Launcher" check box.
- 133 -
r must be enabled in the System Settings Menu.
, follow the steps below.
eset or full-reset.
file).
sing
Advertisement
Table of Contents
