Rocker Assembly; Operation 3-2 To Remove - Perkins 900 Series Workshop Manual

900 Series

Rocker assembly

To remove
1 Remove the rocker cover, see Operation 3-1.
2 Release the nuts (A2) which are toward the valves. Release the nuts (A1) which are toward the push rods.
Remove the nuts and lift off the top half-brackets (A4).
3 Lift off the rocker assembly together with the centre, lower half-brackets. If necessary, lift off the outer, lower
half-brackets (A3).
Note: There is a hollow pin in the centre, lower half-bracket to correctly position the rocker shaft. The shaft is
in the correct position when the hollow pin is located in the rocker shaft. This is to ensure correct lubrication of
the rocker shaft assembly.
4
3
A
Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale
1
2
C0025
3
Operation 3-2
37