Perkins 900 Series Workshop Manual page 212

12
To dismantle
Special requirements
Description
Puller
1 Remove the coolant pump (A4) from the engine, see Operation 12-4.
2 Withdraw the hub (A1) with the puller and the adaptors.
3 Support the pulley end of the pump body. Use a suitable adaptor to press the shaft and bearing assembly
(A2) through the impeller (A5) and coolant seal (A3). Continue to press until the shaft and bearing assembly
are out of the pump body.
4 Discard the impeller and the shaft and bearing assembly. Remove and discard the coolant seal.
5 Clean the body of the pump with a suitable safe cleaning fluid. Inspect the pump body for cracks.
2
1
A
202
This document has been printed from SPI². Not for Resale
Special tools
Part number
21825565
4
3
5
C0092
Description
Adaptors (for use with the puller)
Workshop Manual, TPD 1345E, issue 3
900 Series
Operation 12-6
Part number
21825568