Perkins 900 Series Workshop Manual page 213

900 Series
To assemble
Special requirements
Consumable products
Description
POWERPART Retainer (oil tolerant)
Notes:
l The service kit for the pump contains a bearing and shaft assembly, a coolant seal and an impeller.
l The bearing is filled with grease and sealed by the manufacturer. The bearing will not need attention during
service.
1 Support the impeller end of the pump body. Apply a narrow ring (A3) of POWERPART Retainer (oil tolerant)
to the face of the outer race of the bearing (A2).
2 Put the bearing and shaft assembly into position on the pump body (A5). The smallest shaft diameter must
enter the pump body first. Use a suitable adaptor on the outer race of the bearing and press the bearing and
shaft assembly into the pump body until the outer race of the bearing is level with the pulley end of the pump
body. Do not apply pressure to the end of the shaft as this will damage the bearing. Remove excess retainer.
3 Support the pulley end of the pump body and fit a new coolant seal (A4) using the following procedure.
2
1
A
Workshop Manual, TPD 1345E, issue 3
This document has been printed from SPI². Not for Resale
Part number
21820603
5
4
3
6
C0092/A
12
Operation 12-7
Continued
203