Command #174: Write Alarm Setpoints - MSA Ultima X Series Installation & Maintenance Instructions Manual

Command #174: Write Alarm Setpoints

Writes the Ultima Alarm Setpoint values. The Ultima Gas Monitor uses
alarm setpoint values to set alarm status bits in the device. The alarms
can be enabled or disabled, set to increasing or decreasing and can be
set to latching (see "Command 175: Write Alarm Setpoint Control
Actions"). The adjustment range is greater than zero and less than full -
scale.
Request Data Bytes
BYTE FORMAT
0 Unsigned
1-4 Float
Response Data Bytes
BYTE FORMAT
0 Unsigned
1-4 Float
Command-Specific Response Codes
CODE CLASS
0 Success
1-2
3 Error
4 Error
5 Error
6
7 Error
8-15
16 Error
17-18
19 Error
20-31
32 Error
33-127
DESCRIPTION
Alarm Number (1, 2, or 3)
Alarm Setpoint Value
DESCRIPTION
Alarm Number (1, 2 or 3)
Alarm Setpoint Value
DESCRIPTION
No Command-Specific Errors
Undefined
Parameter too large
Parameter too small
Too few data bytes
Undefined
In write protect mode
Undefined
Access Restricted
Undefined
Invalid device variable index
Undefined
Busy
Undefined
D-15