Figure A-2. Relay Printed Circuit Board
•
Route this cable with DC power to avoid noise interference
from relay wiring.
b. Connect the two-conductor cable to the two positions of
terminal block J10.
c. Identify the cable to enable proper connection at the
button.
d. Route cable to the push-button location; wire the button.
6. Re-install the wiring plugs.
•
Ensure that wiring plugs are firmly seated into their mates.
7. Pull the cable away from the unit to relieve any excess slack.
•
It is important not to have excess wire or cable within the
module to avoid unwanted AC noise.
8. Re-install the cover of the Ultima X Series Gas Monitor.
A-6