Cleaning The Adf (With A Cloth) - Fujitsu fi-7800 Operator's Manual

Cleaning the ADF (with a cloth)

Use a cloth moistened with Cleaner F1 or a Cleaning Wipe to clean the inside of the ADF.
The inside of the ADF becomes very hot when the scanner is being used.
CAUTION
Before you start cleaning the inside of the ADF, make sure to turn off the power, unplug the
power cable and wait for at least 15 minutes for the inside of the ADF to cool down.
ATTENTION
If the hopper has been raised, bring it back down to the lower position.
For details, refer to Setting the Loading Capacity of the Hopper (page
1
Turn off the scanner, unplug the power cable and wait for at least 15 minutes.
For details, refer to
2
Open the hopper/ADF/top cover.
For information on how to open the hopper, refer to
For information on how to open the ADF, refer to
For information on how to open the top cover, refer to
CAUTION
3
Use a cloth moistened with Cleaner F1 or a Cleaning Wipe to clean the following locations.
Pick Roller (2 units)
Gently wipe the rollers so that the roller surface does not get damaged.
Wipe along the grooves of the roller surface. Make sure to clean thoroughly because the feeding
performance is affected especially when there is black foreign matter on the roller. Remove the rollers
for easier cleaning. For information on how to remove the pick rollers, refer to
(page 139).
How to Turn the Power OFF (page
When the ADF/top cover is open, it might close accidentally. Be careful not to get
your fingers caught.
31).
21).
How to Open the Hopper (page
How to Open the ADF (page
How to Open the Top Cover (page
121
Daily Care
22).
26).
29).
Replacing the Pick Roller