Fujitsu fi-7800 Operator's Manual page 210

Item Description
It can also be configured from
the scanner driver's setup
dialog box. Note that priority is
given to the setting with a
larger value.
Document check Selected range: Select this item
area specification to restrict the area to run
for Multifeed multifeed detection on.
Detection
Enable/Disable (Left/Middle/
Right): Specify whether to
enable or disable multifeed
detection for the specified
area.
Start: Specify the start point of
the check area in length (mm)
from the top edge of the
document.
End: Specify the end point of
the check area in length (mm)
from the top edge of the
document.
Intelligent When there is paper of the
Multifeed Function same size attached to a
designated location on the
page, configure the scanner to
memorize the location of the
attachment and not detect
multifeeds for that location.
Note that you first need to
select [Check Overlapping
(Ultrasonic)] for the multifeed
detection setting in
a Multifeed Detection Method
[Multifeed] (page 252)
scanner driver's setup dialog
box.
It can also be configured from
the operator panel.
Select to clear the overlap
pattern (length, location)
memorized in Auto mode.
Setting/Value
(A: Image, B: Filled area, A+B:
Output)
[Selected range] check box
Enable / Disable
(when [Selected range] is
selected)
0 to 510 mm (in increments of
2 mm)
0 to 510 mm (in increments of
2 mm)
Manual mode / Auto mode 1 /
Auto mode 2
Specifying
or the
[Clear overlap pattern] check
box
210
Operational Settings
Factory Default
Not selected
Disable
0 mm
0 mm
Manual mode
Not selected