●
Are the pick rollers, separator roller and brake roller worn out?
Solution
Use one of the following methods to check the pick roller, separator roller, and brake roller counters, and
replace the pick rollers, separator roller, and brake roller if necessary.
● You can select [23: Show/Clear Counters] from [Main Menu] on the operator panel to check the number
of sheets that have been scanned.
For details, refer to
● You can start up the Software Operation Panel to check the number of sheets that have been scanned.
For details, refer to
For details about replacing the pick rollers, separator roller, and brake roller, refer to
Roller (page
139),
●
Did you adjust the paper separation force on the operator panel?
Solution
Lower the paper separation force if it is set high.
For details, refer to
Checking and Resetting the Counters (page
Checking the Sheet Counters (page
Replacing the Separator Roller (page
Adjusting the Paper Separation Force (page
183
83).
216).
142), and
Replacing the Brake Roller (page
37).
Troubleshooting
Replacing the Pick
147).