GIRBAU EH020 Operating Instructions Manual page 27

•
Interrupting a program; during a cycle operation the stop can be activated at
any time. Pressing the "Stop" key signals the control to turn off all power to
washers outputs allowing drain to open, door unlock time count down and all
other cycle functions to halt. Once the control times out and door is opened cycle
is terminated, if the door is not opened then press the start key and cycle will
resume at the beginning of phase when stop key was pressed.
•
Emergency stop; pressing the E-Stop interrupts the washer operation similar to
interrupting the program. After a delay of approximately 3 minutes the door
unlocks.
Note: Be sure to open loading door prior to restoring power or door will relock as
soon as power is restored.
Other stopping modes
•
Turn off power at I/O switch on front of control panel
•
Turn off power at switch disconnector located on rear left of unit
•
Turn off power at power supply source (wall disconnect or breaker panel)
2 7