GIRBAU EH020 Operating Instructions Manual page 13

Thermister; is a probe located under washer outer drum at its lowest point just left of
center, where it will allow contact with water entering washer drum. The temperature of
the water is sent from thermister to washer control and in turn the control activates fill
valve required to produce programmed temperature of wash bath.
At this point the washer's control signals the VFD regarding speeds and rotations.
Control times out, allowing washer to drain and start next sequence of programming until
final phase at which time the unit has final draining and extraction starts. After extraction
is completed washer drum rotates to a stop allowing for door to unlock ending
programmed cycle.
Stop modes
•
End of cycle; when programmed cycle is finished the display shows "End" with
door open light on is considered normal
•
Interrupting a program; during a cycle operation the stop can be activated at
any time. Pressing the "Stop" key and holding for 3 seconds, signals the control
to turn off all power to washers outputs allowing drain to open, door unlock time
count down and all other cycle functions to halt. Once control times out and door
open light shows it is possible to open door. With this scenario, if the door is
opened the customer will lose vend. If customer leaves door closed and presses
the program number that they were using the door will relock and cycle will
resume at the beginning of the phase in which stop was pressed and complete
cycle.
Note: All controls using software 31/65 and later has a 3 second delay when
pressing stop key, indicating key has to be pressed and held in for 3 seconds to
activate.
•
Interruption of power supply; In case of a power failure to building or individual
unit, the micro no longer controls the door lock. All locks have a thermal device
that hold door lock in lock position. It can take up to three minutes for this device
to cool down to a point before the customer or person can open door.
Note: If at some time the washer cycle finishes and the door fails to unlock, you
can turn off power to washer and wait for 3-5 minutes, then push in on the door
then pull to open. After door is opened you can restore power.
Introduction and Use (Logi control)
This guide is intended to inform owner/operator of operation and basic equipment set up
for Logi controlled washing machines.
1 3