GIRBAU EH020 Operating Instructions Manual page 18

Starting a program Logi Control
•
Close loading door, PR ** report on display(indicating last program run)
•
Place laundry products into dispenser
•
Select desired program using up arrow or down arrow keys
•
Press start key; the display will show a temperature value (f *** ) indicates main
bath temperature of selected program. Using the up
possible to modify before starting cycle.
•
Press start key again to confirm temperature and start wash program.
Sequence of starting a program is the same on all EH030, EH040 & REM025, RMG033,
040 and 055 model washers with normally open door locks. Models EH060, 070, 080
and RMG070 use normally closed door locks.
Start signal activated by operator with press of start key, signal is sent to door lock to
start locking process and drain valve causing valve to close.
Door lock normally open; after the lock has received a start signal, a 30 second delay
time is started, during this time the drum rotation and water inlet operate at short
impulses and door remains unlocked. Anytime during this period, the user can open and
close the door up until it locks. At the end of the 30 seconds the door will lock and cycle
time starts.
Door lock normally closed; after lock has received a start signal the door locks within a
moment and cycle starts. Door remains locked until a signal is sent from contr5ol to
unlock.
arrow or down
1 8
arrow it is