GIRBAU EH020 Operating Instructions Manual page 10

As we can see there are several options in this menu screen. The one we want to
address is SP 0 showing in chart as Levels of suds prevention. What it doesn't tell us
is that it is also the setting for Energy Star programs. These default programs use lower
water levels, lower water temperatures and shorter cycle times.
If we want the washer to work at a standard level of customer satisfaction, we need to
change this setting from SP-0 to SP-1. This will increase the main wash levels,
temperature and times of cycles.
Note:
In order to understand the change of cycles from SP-0 to SP-1 look in section
6.2.2 Program contents. USA configuration, all models. SP-0 and compare to
EH020 and REM025 models. SP-1, SP-2, SP-3. Other EH and RMG models SP-1.
To change setting SP-0 to SP-1, washer display shows Nod, press number 1 until
display shows SP-0, press number 2 and change to SP-1. Press number 1 and you will
hear a long beep then display will show Id-0.
Note: The Id setting is the connection setting for Card systems that allows for the
card provider to communicate directly with washer control through an interface
set up. All washers connected to card systems using this interface requires the Id-
0 setting to be changed to Id-1.
Activation of card system interface;
With display showing Id-0 press number 2 and display will show Id-1 indicating
activation. Press number 1 to confirm change and display will show Nod.
At this time we have completed all standard washer settings and units are now ready for
customer use.
To exit the COD settings press the stop key and display will show door indicating door is
open or Sel indicating door is closed and that washer is in ready mode.
Machine Operation
Main reports that appear on washer display are shown in chart;
Loading the washing machine
Open the loading door and load the machine. Washer load recommendations according
to the type of linen to be washed;
a. Cotton fabrics: nominal load of approximate machine capacity
b. Synthetic fabrics: between 80 & 90% of nominal load
1 0