Application As Directed - Lenze i550-C0.25/120-1 Project Planning Manual

Application as directed

The product must only be operated under the operating conditions prescribed in this
•
documentation.
The product meets the protection requirements of 2014/35/EU: Low-Voltage Directive.
•
The product is not a machine in terms of 2006/42/EU: Machinery Directive.
•
Commissioning or starting the operation as directed of a machine with the product is not
•
permitted until it has been ensured that the machine meets the regulations of the EU
Directive 2006/42/EU: Machinery Directive; observe EN 60204−1.
Commissioning or starting operation as directed is only permissible if the EMC Directive
•
2014/30/EU is complied with.
The harmonised standard EN 61800−5−1 is applied.
•
The product is not a household appliance, but is only designed as a component for
•
commercial or professional use in terms of EN 61000−3−2.
The product can be used according to the technical data if drive systems have to comply
•
with categories according to EN 61800−3.
In residential areas, the product may cause EMC interferences. The operator is responsible
for taking interference suppression measures.
The product must only be actuated with motors that are suitable for the operation with
•
inverters.
Lenze L-force motors meet the requirements
-
Exception: m240 motors are designed for mains operation only.
-
Use of explosion-proof motors
Explosion-proof motors that are not designed for use with an inverter invalidate their approval
when used for variable speed applications. Due to the many areas of liability that may arise
when handling these applications, the following declaration of principle applies:
The inverters from Lenze are sold without warranty of suitability for a particular
purpose or warranty of suitability for use in explosion-proof motors. Lenze
assumes no responsibility for any direct, incidental, or consequential damages,
costs, or losses that may result from the use of AC inverters in these
applications. The purchaser explicitly agrees to assume any risk of loss, cost or
damage that may result from such use.
The user is not allowed to change inverters that come with integrated safety technology.
The safety module must not be removed. If the safety module is defective, the inverter has to
be replaced.
Information on project planning
Safety instructions
Application as directed
35