Application As Directed - Lenze i510 Operating Instructions Manual

General information
Overview Information

Please read this documentation carefully before installing the inverter and observe the safety
instructions!

This document only includes the most frequently asked questions and presents them in a
simplified form for a better overview. Detailed technical and functional explanations can be

found in the comprehensive product documentation. The complete documentation, further
information and tools regarding Lenze products can be found on the Internet:
www.Lenze.com


Application as directed

• The product is a piece of professional equipment intended for use by trades, specific

professions or industry, and not for sale to the general public. IEC 60050 [IEV161-05-05]
• To prevent personal injury and damage to property, higher-level safety and protection

systems must be used!
• All transport locks must be removed.

• The product may only be operated under the specified operating conditions and in the
specified mounting positions.
• The product is only suitable for installation in control cabinets and, depending on the

protection class, for wall mounting.
• The product must only be actuated with motors that are suitable for the operation with

inverters.
• The product must not be operated in private areas, in potentially explosive atmospheres
and in areas with harmful gases, oils, acids and radiation.
Device-specific standards and directives
• The product meets the protection requirements of the Low-Voltage Directive 2014/35/EU.
• The harmonized standard EN IEC 61800-5-1 is used for the inverters. (Europe).
• UL 61800-5-1 and CAN/CSA C22.2 No.274 are the North American electrical safety
standards.
© 11/2021 · EN · www.Lenze.com
Identification Conventions
Relevant standards and directives for the operator
• If the product is used in accordance with the technical data, the drive systems comply with
the EN IEC 61800-3 categories (Category C2 is similar to FCC Class A).
• The test voltage for insulation resistance tests between a control potential of 24 V and PE
must be measured in accordance with EN IEC 61800-5-1.
• The cables must be installed in accordance with EN IEC 60204-1 or US National Electrical
Code NFPA 70/Canadian Electrical Code C22.1.
Commissioning
• Commissioning or starting the operation as directed of a machine with the product
is prohibited until it has been ensured that the machine meets the regulations of the
Machinery Directive 2006/42/EG and the standard EN IEC 60204-1.
• Commissioning or starting the operation as directed is only permissible if the EMC Directive
2014/30/EU is complied with.
• In residential areas, the product may cause EMC interference. The operator is responsible
for executing the interference suppression measures.
Operating instructions i510 cabinet frequency inverter | 3