Power Sensor Tour; Rf Connector - R&S NRPxxS Series User Manual

®
R&S NRPxxS(N)

4 Power Sensor Tour

This chapter provides an overview of the available connectors and LEDs of the power
sensor.
In Figure
shown on the right.
Figure 4-1: R&S NRP series power sensors (example)
1 = RF connector, see
2 = Trigger I/O connector, see
3 = Host interface connector, see
4 = Status LED, see
5 = LAN connector, see
6 = LAN reset button, see
7 = Power over Ethernet status LED, see
8 = Network status LED, see

4.1 RF Connector

The RF connector is used for connecting the power sensor to a device under test
(DUT) or a signal generator.
For maximum measurement accuracy, tighten the RF connector using a torque wrench
with a nominal torque as specified in the following table.
User Manual 1177.5079.02 ─ 10
4-1, the USB power sensor is shown on the left, the LAN power sensor is
2
3
4
Chapter 4.1, "RF
Chapter 4.2, "Trigger I/O
Chapter 4.3, "Host
Chapter 4.4, "Status
Chapter 4.5, "LAN PoE
"LAN reset button"
"Network status LED"
1
7
8
5
6
2
3
Connector", on page 23
Connector", on page 24
Interface", on page 24
LED", on page 25
Interface", on page 25
on page 26
"Power over Ethernet status LED"
on page 26
Power Sensor Tour
RF Connector
4
on page 26
1
23