R&S NRPxxS Series User Manual page 35

®
R&S NRPxxS(N)
Required equipment
●
R&S NRPxxS(N) power sensor
●
R&S NRP‑ZKU cable or an R&S NRP‑Z5 sensor hub and an R&S NRP‑ZK6 cable
to connect the sensor to the computer
●
Computer with installed:
–
–
If you want to use an android device like a tablet or a smartphone, use the R&S Power
Viewer Mobile. For details, see
on page 37.
Setup
Figure 5-3: Setup with the R&S Power Viewer
1 = Signal source
2 = R&S NRPxxS(N) power sensor
3 = Host interface connector
4 = R&S NRP‑ZKU cable
5 = USB connector
6 = Computer with installed R&S Power Viewer
Incorrectly connecting/disconnecting the R&S NRPxxS(N) power sensors can damage
the power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensor as described in
"Preparing for
Starting a measurement
1. Connect the cables as shown in
For a detailed description, refer to
on page 14.
2. Start the R&S Power Viewer.
3. Execute zeroing:
User Manual 1177.5079.02 ─ 10
R&S NRP Toolkit V 4.17 or higher
R&S Power Viewer version 9.2 or higher (refer to the operating manual of the
R&S Power Viewer for a description of the installation process)
Use", on page 11.
Chapter 5.6, "R&S Power Viewer
Figure 5-3.
Chapter 3.5.1.1, "Simple USB
Operating Concepts
R&S Power Viewer
Mobile",
Chapter 3,
Connection",
35