R&S NRPxxS Series User Manual page 16

®
R&S NRPxxS(N)
1
2
3
4
5
6
7, 8
9
10
11-14 = R&S NRP‑ZK6 cable
15
16
17
Incorrectly connecting/disconnecting the R&S NRPxxS(N) power sensors can damage
the power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensor as described in
"Preparing for
1. Connect the cables as shown in
a) Connect the R&S NRP‑ZK6 cable to the power sensor.
b) Connect the power sensors to the R&S NRP‑Z5 sensor hub. You can connect
c) Connect the R&S NRP‑Z5 to the computer.
d) Connect the power sensors to the signal source.
e) Connect the delivered external power supply unit to the R&S NRP‑Z5 and to an
f)
g) Connect the trigger output of the R&S NRP‑Z5 with a BNC cable to the trigger
2. On the computer, start a software application to view the measurement results.
See
3.5.2 Setting Up a LAN Connection
Requires power sensors with networking capabilities, the R&S NRP LAN power sen-
sors.
This section describes how to connect the sensor to a LAN network and configure the
LAN interface for establishing a connection.
User Manual 1177.5079.02 ─ 10
= R&S NRP‑Z5 sensor hub
= External power supply unit (supplied)
= Power cable (supplied)
= AC power supply
= USB cable (supplied)
= Computer with USB host interface
= BNC cable (optional, not supplied)
= Trigger source (optional)
= Triggered device (optional)
= Host interface connector
= R&S NRPxxS(N) power sensor
= Signal source
Use", on page 11.
up to four sensors.
AC supply connector.
Connect the trigger input of the R&S NRP‑Z5 with a BNC cable to the trigger
source (optional).
device (optional).
Chapter 5, "Operating
Figure 3-2:
Concepts", on page 27.
Preparing for Use
Connecting to a Computer
Chapter 3,
16