R&S NRPxxS Series User Manual page 55

®
R&S NRPxxS(N)
Remote command:
TRIGger:HYSTeresis
6.5.4 System Settings
Describes the parameters of the general network environment and specific identifica-
tion parameters of the power sensor in the network.
Further information:
●
Chapter 9.11, "Configuring the
Access: main dialog of the web user interface > navigation pane > "System"
IP Address.....................................................................................................................55
Subnet
Gateway........................................................................................................................ 56
DHCP............................................................................................................................ 56
Apply Network
Sensor
Firmware
IP Address
Sets the IP address of the sensor.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress
Subnet Mask
Sets the subnet mask.
The subnet mask consists of four number blocks separated by dots. Every block con-
tains 3 numbers in maximum.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress:SUBNet:MASK
User Manual 1177.5079.02 ─ 10
on page 84
Mask................................................................................................................. 55
Settings................................................................................................. 56
Name................................................................................................................ 56
Update...........................................................................................................56
Browser-Based User Interface
System", on page 128
on page 130
Settings
on page 131
55