R&S NRPxxS Series User Manual page 114

®
R&S NRPxxS(N)
Figure 9-8: Correction of interactions between the power sensor and the signal source
If the gamma correction is performed in combination with an S-parameter correction
([SENSe<Sensor>:]CORRection:SPDevice:STATe
account:
●
Interaction of the signal source with the S-parameter device
●
Input of the power sensor, depending on the transmission, expressed by the term
s
If the S-parameter correction is enabled, the interaction between the complex reflection
coefficient Γ
always taken into account, regardless whether gamma correction is performed or not.
Figure 9-9: Correction of interactions between the power sensor, the signal source, and the S-param-
Remote commands:
[SENSe<Sensor>:]SGAMma:CORRection:STATe
[SENSe<Sensor>:]SGAMma:MAGNitude
[SENSe<Sensor>:]SGAMma:PHASe
[SENSe<Sensor>:]SGAMma:CORRection:STATe <state>
Enables or disables the use of the complex reflection coefficient to correct the interac-
tions of power sensor and signal source.
Parameters:
<state>
Manual operation:
[SENSe<Sensor>:]SGAMma:MAGNitude <magnitude>
Sets the magnitude of the complex reflection coefficient of the source, Γ
User Manual 1177.5079.02 ─ 10
Sensor
s
12 21
of the power sensor and the reflection of port 2, expressed by s
sensor
Sensor Source
eter device
*RST:
See "<State>"
Configuring Basic Measurement Parameters
Source
S
21
S
S
11
22
S
12
..............................................................114
......................................................................... 114
................................................................................115
OFF
on page 49
Remote Control Commands
NRP
3-Path Diode Power Sensor
MHz to GHz, 100 pW to 200 mW (−70 dBm to +23 dBm)
SMART SENSOR TECHNOLOGY
ON), the following is taken into
NRP
3-Path Diode Power Sensor
MHz to GHz, 100 pW to 200 mW (−70 dBm to +23 dBm)
SMART SENSOR TECHNOLOGY
.
source
, is
22
114