R&S NRPxxS Series User Manual page 121

®
R&S NRPxxS(N)
6. Create a backup of the calibration data set before making any changes.
Select "File" > "Save Calibration Data".
A dialog opens where you can select the location to save the calibration data.
To change the S-parameter data
1. In the device table, double-click an entry. See also
2. Select "File" > "Import S2P".
3. Select the *.S2P file you want to import, and confirm with "Open".
The data from the selected file is loaded in the device table.
All uncertainties are set to zero.
User Manual 1177.5079.02 ─ 10
Remote Control Commands
Configuring Basic Measurement Parameters
"Device table" on page 119.
121