Wiring Vi15X Inputs And Outputs; Connecting The Vi15X Voltage Module And A Dx1Xx Io Module - ABB UMC100-FBP Technical Description

Universal Motor Controller
UMC100-FBP
Technical Description

Wiring VI15x Inputs and Outputs

The diagram below shows the block diagram and wiring of both the VI150 and the VI155 modules.
The relay output is a normally open contact and can be freely used.
The inputs L1, L2, L3 must be connected to to corresponding supply phases.
The 0V of the VI150 supply must be connected to ground for proper measurement.
24VDC
G N D
*)
1CA
2CA
1CB
2CB
*) Functional earthing only VI150
Funktionserde nur VI150
 Wiring diagram of the VI15x-FBP modules

Connecting the VI15x Voltage Module and a DX1xx IO Module

To connect both a VI15x and a DX1xx module to the UMC use the UMCIO-CAB cable to connect the first
module with the UMC. And use the IOIO-CAB cable to connect the first module with the second module.
The module order does not matter.
UMC100-FBP
Ready Error
Warn
#)
RX / TX
#) Only VI155
Nur VI155
- 20 -
VI15x
/
Logic
µ C
DO0
DOC
L1
L2
L3
L1
L2
L3
FieldBusPlug / Issue: 03.2012