ABB UMC100-FBP Technical Description page 107

Universal Motor Controller
UMC100-FBP
Technical Description
Acknowledge a Fault
If a fault is present the 'Cntrl' menu is replaced with the menu to acknowledge faults (top level menu, left
hot key). While a fault is present it is not possible to enter the Motor Control menu until the fault has been
acknowledged. When entering the error menu the latest fault message is displayed. By pressing the right
hot key 'Reset' you acknowledge the fault.
If there is another fault pending it is displayed and can also be acknowledged until there is no further fault
pending. Using the up/down keys it is possible to scroll through the list of present faults before acknowl-
edging them. If the last fault was acknowledged the main menu is automatically entered.
The menu can be exited at any time pressing the left hot key 'Back' without resetting any faults.
Ins Menü 'Fehlerquittieren'
wechseln /
Change to menu ack. fault
FieldBusPlug / Issue: 03.2012
Fehler Indikator /
fault indication
Linker Hotkey
(Error) gedrückt /
Left hotkey (error)
pressed
Zurück ins
Hauptmenü /
Back to main
menu
The table in the section "Error Handling, Maintenance and Service->Error Handling of
the UMC" lists all diagnosis and fault messages and potential root causes for the fault.
It gives you a first indication of where to look for a fault and how to fix it. Use the error
number shown in the heading (Error 83 in the example) for the look-up table.
Automatisch wenn der letzte
Fehler quittiert wurde /
Automatically when the last fault
was acknowleged.
- 107 -
Fehler quittieren /
Ack. fault
Vorheriger Fehler /
Previous fault
Nächster Fehler /
Next fault
UMC100-FBP