Table of Contents
Advertisement
1.8.1 Setting public holidays
On public holidays, the times-of-use specified for Sunday apply.
A maximum of 20 public holidays may be entered.
Parameter
Public holidays
Proceed as follows:
To enter additional public holidays, re-select – – . – – and repeat the steps 4 to 6.
Note: Public holidays can also be set in PA5 parameter level (–> section 2.3).
Deleting a public holiday:
1.
Under data point for public holidays, select the holiday you wish to delete [q].
2.
Confirm selection [ ].
3.
Select – –.– – [q].
4.
Confirm selection [ ].
The public holiday is deleted.
Note: Public holidays that are not assigned to a specific date should be deleted by the end of the
year so that they are not carried on into the following year.
WE
Level / Range of values
–
Extended information level/ 01.01 to 31.12
1.
In the extended information level (normal switch
position
) select data point for public holidays [q].
Display:
2.
Open data point for public holidays.
3.
If applicable, select – – – – .
4.
Activate editing mode for public holiday [ ].
and
blink.
5.
Select public holiday [q].
6.
Confirm public holiday [ ].
Operation
15
EB 5573 EN
Hide quick links:
Advertisement
Table of Contents
