Inserting A Buttonhole Within A Sequence; Switching Off Sequential Mode - DURKOPP ADLER 581 Operating Instructions Manual

Programming
Operating Instructions 581 - 02.0 - 05/2019
5.4.3

Inserting a buttonhole within a sequence

It is not possible to insert buttonholes individually into the sequence.
Note the current sequence programming and change the sequence
accordingly ( p. 72).
You can also switch off sequential mode.
5.4.4

Switching off sequential mode

If you want to use single buttonhole mode instead of sequential
mode, switch off sequential mode.
To switch off sequential mode:
1. Press the
2. Use the button
number ( p. 66).
3. Press the
4. Use the button to select the sequential number 0.
5. Press the
 The sequential mode is switched off.
6. Press the
 The setting mode is ended. This will take you back to
the operator level.
button.
to navigate to the field Sequential
button.
button.
button.
81